10
Wired Ethernet LAN
You can easily connect any PC with an Ethernet cable to the Connect Box Ethernet port.
Because the Connect Box Ethernet port supports auto-MDIX, you can use a straight-
through or cross-over cable to connect a hub, switch, or computer. Use category 5,
or better, cabling for all Ethernet connections.
Sample Ethernet to Computer Connection (Connect Box model shown)
A wired Ethernet LAN with more than four computers requires one or more hubs,
switches, or routers. You can:
Connect a hub or switch to any Ethernet port on the Connect Box.
Use Ethernet hubs, switches, or routers to connect up to any combination of
253 computers and wireless clients to the Connect Box.
More detailed information on Ethernet cabling is beyond the scope of this document.
Front Panel
The Connect Box front panel contains indicator lights and the Wi-Fi / WPS button which
is used to configure Wi-Fi Protected Security (WPS) on compatible clients connected to
the Connect Box network.
The Connect Box front panel LED indicators provide the following status information
for power, communications, and errors:
S.no LED Status On
1 WI-FI
Red: Wireless function is fail.
Green: Wireless interface is
active now.
2 Internet Blinking Green :Scanning for
Internet connection, trans-
mitting or receiving data over
the Internet
Green: Connected to Internet
3 TEL LED does not blink Green: Telephone is
connected and activated;
on-hook
1
2
3
4
5
To Next Page
Loading...
Need help?
General
