4/7
Step 3 - Color Registration Adjustment-
A) CDC 1626, CDC 1726, CDC 5526L, CDC 5626L / DCC 2626, DCC 2726, DCC 6526L, DCC 6626L
Following procedures are the same contents as [Color Registration Procedure (Detailed Setting) in Operation Guide.
1. In the Sys. Menu/Count. Menu , press the Upward or Downward key to select Adjust/Maint. (Fig.3)
2. Press the OK key. The Adjust/Maint. menu appears.
3. Press the Upward or Downward key to select Color Calibration (Fig.4)
4. Press the OK key. Color Calibration appears.
5. Press Yes (the Left Select key) to execute Color Calibration . (Fig.5)
(Completed. is displayed and the screen returns to the Adjust/Maint. menu.)
5. Press the
Upward or Downward key to select Color Regist. .
6. Press the OK key. Color Regist. appears. (Fig.6)
7. Press the Upward or Downward key to select Detail .
9. Press the OK key. The Detail registration appears. Press the Upward or
Downward key to select Print Chart . (Fig.7)
10. Press the OK key. The chart print confirmation menu appears.
11. Press Yes (the Left Select key) to execute chart printing. After the charts
are printed, you will return to the standard menu of color print position
correction. Two charts, H-1 to H-5V (upper) and V-3 (lower) are printed on
one sheet of paper for each of the colors M (magenta), C (cyan), and
Y (yellow). (Refer to [Chart example])
12. Press the Upward or Downward key to select Adjust Magenta . (Fig.7)
Press the OK key. The magenta correction menu appears.
13. In the color registration correction chart printed in Print Registration Chart above, note the numbers of the sections in the
magenta H and V charts where the lines most closely coincide as a single straight line. In the left example, the value
would be B. (Fig.9)
14. Press the
Leftward or Rightward key to change items (H-1 to H-5, V-3). Press the Upward or Downward key to enter
the value read from the chart and press OK . (Fig.10)
Magenta correction is performed. After a brief interval you will return to the standard menu of color print position
correction.
Press the upward key to increase the value from 0 to 9. To decrease, press the Downward key.
By pressing the Downward key, the value changes from 0 to alphabetic letters, going from A to I. To move in the reverse
direction, press the Upward key.
You cannot use the numeric keys to enter these values.
15. Repeat steps 12 to 14 to correct cyan and yellow.
[Chart example]
(Fig.7) (Fig.8)
(Fig.9) (Fig.10)
(Fig.5) (Fig.6)
(Fig.3)
(Fig.4)
To Next Page
Loading...
Need help?
General
