Default Setting (System Menu)
8-126
AutoColorCorrect
This setting allows you to adjust the detection level used by the machine to determine whether the original is
color or black and white during Auto Color Mode. Setting a lower value will result in more originals being
identified as color, while a larger value will tend to increase the number of originals being identified as black and
white.
Use the procedure below to set the Auto Color Detection Level.
1 In the Sys. Menu/Count. menu, press the or
key to select [Adjust/Maint.].
2 Press the OK key. The Adjust/Maint. menu
appears.
3 Press the or key to select [AutoColorCorrect].
4 Press the OK key. AutoColorCorrect appears.
5 Press the or key to select a value from [5] to
[1].
6 Press the OK key. Completed. is displayed and the
screen returns to the Adjust/Maint. menu.
ColorCalibration
This machine contains a calibration function that automatically makes adjustments to compensate for changes
that occur over time due to variations in the ambient temperature and humidity. So that the highest quality color
printing can be maintained, this color calibration operation is carried out automatically each time the power to
the machine is turned on. If color tone does not improve or color drift does not improve after executing this color
adjustment, perform color print position correction on page 8-127
.
To Next Page
Loading...
Need help?
General
