4.3.1 Maximum dive depth alarm
By pressing the SEL button in this menu the
depth value starts blinking. By pressing the
+/UP or -/DOWN buttons the value can be
selected from 5 up to 100 meters (20..330
feet) in 1m/5ft increments. By pressing the
SEL button the function starts blinking and
you may select on or off by pressing the
+/UP or -/DOWN buttons. The selection is
confirmed by pressing the SEL button.
4.3.2 Maximum dive time alarm
By pressing the SEL button in this menu
the time value starts blinking. By pressing
the +/UP or -/DOWN buttons the value
can be selected from 5 up to 195 minutes
in 5 minutes increments. By pressing the
SEL button the function starts blinking and
you may select on or off by pressing the
+/UP or -/DOWN buttons. The selection is
confirmed by pressing the SEL button.
4.3.3 Setting the Micro Bubble level
By pressing the SEL button in this menu
the Micro Bubble level starts blinking. By
pressing the +/UP or -/DOWN buttons you
may select personal setting from L0 up to
L5 which is the most conservative setting.
The selection is confirmed by pressing the
SEL button.
F
NOTE: More about diving with the MB
levels, can be found in section: Diving
with MB levels.
4.3.4 Units
You may select between depth and
temperature unit combinations. The effect
takes place in dive mode, in the log book,
alarm settings, altitude settings etc.
By pressing the SEL button the depth
field starts blinking and the value may be
changed between meters/feet by pressing
the +/UP or -/DOWN buttons. By pressing
the SEL the temperature units start blinking
and the value can be changed between
°C/°F by pressing the +/UP or -/DOWN
To Next Page
Loading...
Need help?
General
