communication between your PC and
MANTIS with a cradle.
To start the communication
1. Connect the cradle to your PC
2. Launch LogTRAK on your PC
3. Select the serial port where the cradle is
connected
Extras -> Options -> download
Select the COM port that is used for
MANTIS cradle.
4. Place the MANTIS on the cradle.
Download dive profiles
From LogTRAK, by selecting Dive ->
Download Dives you can transfer the
MANTIS Logbook to your PC or Mac.
There are three main views each showing a
specific part of your dive logs:
Profile shows the graphical data of the dive.
Details about the dive, where you can edit, for
example, the equipment and tank information.
Location, shows your dive site on the
world map.
The selection tabs for views are on the left
side of the main window.
6.3 Change warnings/
settings of the mantis
and reading the
computer information
By selecting Extras -> Read Dive Computer
settings you can enable/disable warnings
that cannot be enabled or disabled by
using the menus on the MANTIS unit.
Read the chapter Warnings and alarms
about the possible selections that you can
modify on your MANTIS.
You may also change the shown units
between metric/imperial. Select Extras ->
Options -> measurement units:
To Next Page
Need help?
General
