In SWIM mode and during surface exercise,
MANTIS displays the count of strokes or
heart rate on the bottom row, the elapsed
time on the middle row and the converted
total distance on the top row
5. MANTIS ASSESORIES
5.1 HR belt
MANTIS receives the signal of various low
frequency heart rate belts.
The new SCUBAPRO heart rate belt
features a patented skin temperature
measurement and transmission that is
supported by the MANTIS.
HR belt positioning is shown below. Adjust
the strap so that it is comfortable to wear
but stays in place. When wearing a diving
suit the HR belt must be directly against the
skin. Moisten the electrode areas if your
skin is dry or when wearing a dry suit.
F
NOTE: The front side of the temperature
HR belt should be against the suit and
not covered by body parts.
You must enable the heart rate setting on
your MANTIS, refer to the section on Heart
rate limits and Skin temperature to learn
how to do this.
After a dive rinse the heart rate belt in fresh
water, dry it and store in a dry place.
We recommend having the battery
changed by an authorized SCUBAPRO
dealer for HR belts with a battery cap. With
completely sealed HR belts the battery
cannot be changed.
Check the operation conditions and depth
rating of the HR belt from the unit or its
package.
5.2 Nylon arm strap
Divers wearing a thick neoprene wetsuit
or drysuit may prefer a longer arm strap.
MANTIS can be equipped with a one piece
31cm/12inch Scubapro nylon arm strap.
F
NOTE: The MANTIS arm strap is
attached with Solid Stainless Steel pins
that are splintered on one end. Always
push the pins out with the splintered
end first. In the housing the splintered
side can be recognized from the slightly
larger diameter guiding at the hole.
The disassembly and assembly of the
arm strap requires a special tool. We
recommend the arm strap change be
done by authorized SCUBAPRO dealer.
To Next Page
Loading...
Need help?
General
