10
Wall Switch
Remote control handset
Thermostatic
Remote Control
Wall Switch
The battery box, receiver and gas valve are located on
the bottom of the appliance behind the front panel.
Battery box in carrierReceiver
Window
Gas valve
Gas valve
Owner’s Information
Fireplace Control Devices
There are two ways to control
your fi replace.
1. Thermostatic Remote
Control;
2. Wall Switch.
The Thermostatic Remote
Control can be programmed
to function automatically—see pages 10–14.
The Wall Switch can be used to turn on, off and to
increase or decrease the fl ame height—see page 15.
How to Turn Your Fireplace OFF
(including pilot)
Familiarize yourself with each of these methods before
operating your fi replace.
Press and hold the OFF button for a second (either on
the handset or the wall switch).
If the fl ames are on, they go down and you hear the
valve motor wind down. You hear a clunk and a beep
indicating that the valve has received the signal from
the remote control.
How to Ensure Your Fireplace Cannot
Be Turned ON Inadvertently
You can use one of the two following methods to
ensure that your fi replace will not turn on when you
don’t want it on.
First, ensure your fi replace is turned off—including
the pilot—and cold BEFORE going ahead.
• Turn the dial on the gas valve
from the ON position to the MAN
position as shown. Turning the dial
to MAN (arrow up) will ensure that
the main burner can not come on.
The pilot will remain on if it is lit.
• Alternately, remove all batteries from the receiver as
well as the battery from the handset.
Automatic Shut-Off (in certain conditions)
Your fi replace’s remote control is equipped with an
automatic shut-off mechanism which is activated in
certain conditions. See page 14 in the Remote Control
Operation section for a description of this feature.
OWNER’S
INFORMATION
To Next Page
Loading...
Need help?
General
