EasyManuals Logo
Home>Valor>Fireplace Accessories>L2 SERIES

Valor L2 SERIES User Manual

Default Icon
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
11
Remote Control Operation
NOTE: Before using the remote control system for
the rst time, the receiver and the handset must be
synchronized. See the section Initialize Remote Control
on page 53 of this manual.
IMPORTANT: BEFORE YOU BEGIN, please note that
on this system, the settings of time, temperature and
automatic ON/OFF can only be programmed when
the function display is ashing. Be patient when
programming as it can take a few seconds to set.
When the pilot is off, it will take 2
minutes before it can be lit again.
TO TURN ON APPLIANCE TO TURN OFF APPLIANCE
FLAME HEIGHT ADJUSTMENT
On the valve, turn MAN knob on the ON, full
counterclockwise position.
Place ON/OFF switch (if equipped) in I (ON
position).
STANDBY MODE (Pilot Flame)
Press and hold (small ame) to set appliance at
pilot ame.
Simultaneously press the OFF and
(large ame) buttons until a short
beep con rms the start sequence
has begun; release buttons.
Continuing beeps con rm the
ignition is in process.
Once pilot ignition is con rmed,
there is main gas ow.
After main burner ignition the
handset will automatically go into
manual (MAN) control mode.
Press OFF button.
When the pilot is off, it will take 2
minutes before it can be lit again.
In standby mode: Press and hold
(large ame) button to increase
ame height.
CAUTION
When pilot ignition is con rmed, motor turns
automatically to maximum ame height.
Set (scrolls
through
modes and
settings)
OFF (returns
to set mode,
turns the burner
and the pilot o)
Large ame
button (ames
up, sets hours,
temperature)
Small ame
button (ames
down and o,
sets minutes,
temperature)
Current
temperature
(F or C)
Current time
(12 or 24 hour clock)
Modes (Manual,
Temperature, Timer)
Handset
sensor
Battery status
Current
programmed
period (Timer)
Period
start or end
(Temp, Timer)
Display Overview
Handset Overview
Note: In the TEMP or TIMER modes, the remote
handset senses the room temperature and adjusts the
ame accordingly.
To communicate, the handset should be within 15 feet
(4.5 meters) of the replace.
Do not leave the handset on the mantel or hearth.
OWNER’S
INFORMATION

Other manuals for Valor L2 SERIES

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Valor L2 SERIES and is the answer not in the manual?

Valor L2 SERIES Specifications

General IconGeneral
BrandValor
ModelL2 SERIES
CategoryFireplace Accessories
LanguageEnglish

Related product manuals