A-1
Appendix A: EMR
3
Safety Instructions
1. ATEX approved EMR
3
systems are marked with the following information defining its limits for safe use. The
product should not be installed or used in hazardous locations that are not compatible with the following:
EEx ia II A T4
Ui: 13.365 Vdc
Ii: 687 mA
Pi: 2.3 W
Li: 208
μ
H
Ci: 13.3
μ
F
T
amb
-25°C to +70°C
Defined per certification CE
600
II 1G DEMKO SYST 02 ATEX 0216184 EEx ia IIA T4
2. Refer to the site preparation procedures in this manual for general instructions on safe installation, use, and
replacement.
3. The EMR
3
system does require periodic calibration. Follow the calibration procedures outlined in the Veeder-
Root EMR
3
Setup and Operation manual (P/N 577013-766).
4. The EMR
3
system is not serviceable. If a failure occurs, the unit should be replaced in accordance with the
requirements of this manual.
To Next Page
Loading...
Need help?
General
