Vega ATEX User Manual

31
9 Setup with PC/notebook (Bluetooth)
VEGAMET 841 • 4 … 20 mA
58864-EN-200401
Note:
If an incorrect code is entered, the code can only be entered again
after a delay time. This time gets longer after each incorrect entry.
The message "Waiting for authentication" is displayed on the PC.
After connection, the DTM appears.
If the connection is interrupted, e.g. due to a too large distance
between controller and PC, this is displayed on the PC. The message
disappears when the connection is restored.
Parameter adjustment of the device is only possible if the parameter
protection is deactivated. When delivered, parameter protection is
deactivated by default and can be activated at any time.
It is recommended to change the factory default 6-digit device code
"000000" to your personal 4 - 10-digit device code. Go to the menu
"Extended functions", "Access protection", menu item "Protection of
the parameterization".
9.3 Parameter adjustment
For parameter adjustment of the instrument via a Windows PC, the
congurationsoftwarePACTwareandasuitableinstrumentdriver
(DTM) according to FDT standard are required. The latest PACTware
version as well as all available DTMs are compiled in a DTM Collec-
tion. The DTMs can also be integrated into other frame applications
according to FDT standard.
Fig. 12: Example of a DTM view - Adjustment
Connected
Change device code
Prerequisites

Vega ATEX Specifications

General

Brand	Vega
Model	ATEX
Category	Controller
Language	English