Service - 28
CLEANING & GENERAL MAINTENANCE
For best results, and to maintain the fi nish of the power
unit, clean or wash the power unit to remove accumu-
lated clippings, leaves, dirt, gravel, and salt deposits.
Attention
To maintain the fi nish of the power unit, thoroughly wash
the equipment after each use to remove any corrosive
agents (e.g., salt). Failure to clean the equipment may
result in corrosion of (including but not limited to) steel,
aluminum, and electrical components. Equipment that
will experience repeated exposure to corrosive agents
should be pretreated with a corrosion preventative.
SERVICE & MAINTENANCE
Proper and timely service of this power unit is critical
to keep the power unit in a safe and reliable operat-
ing condition. Follow the Maintenance Schedule at
the end of the service section. For convenience, a
Frequent Service Reference Chart has been placed
on the power unit under the hood as shown in the
picture below.
Throughout the Service Section, different access
points are referred to. Below is a list of shields and
covers that may need to be removed or opened dur-
ing service.
A - Engine Hood
B - Pump Cover
C - Rear Frame Tunnel Cover
D - Seat Plate
B
C
D
SERVICE
A
Always set the parking brake, shut off power
unit engine, remove the ignition key, and ensure
all moving parts have come to a complete stop
before inspecting components or attempting any
repair or adjustment.
Attention
If any component requires replacement, use only
original Ventrac replacement parts.
To Next Page
Loading...
Need help?
General
