Visonic POWERMAXEXPRESS Installer's Guide

10 D-303973 PowerMaxExpress Installer's Guide
4. PROGRAMMING
4.1 INTRODUCTION
4.1.1 General Guidance
We recommend to program the PowerMaxExpress on the
work bench before actual installation. Operating power
may be obtained from the backup battery or from the AC
power supply.
The installer’s menu is accessible only to those who know
the installer’s 4-digit code, which is 9999 by factory default.
Note: Access to the installer menu, in PowerMaxExpress
that has "User Permission" enabled (for example in UK) is
accessible only at the end of the user menu. This option can
be changed if necessary (see par. 4.4.36).
For PowerMaxExpress that has 2 installer codes (not
applicable in UK), the default INSTALLER code is 8888
and the default MASTER INSTALLER code is 9999.
The following actions can be done only by using the
master installer code:
 Changing master installer code.
 Resetting the PowerMaxExpress parameters to the
default parameters,
 Defining specific communication parameters, as
detailed in a note in figure 4.5C.
Obviously, you are expected to use this code only once for
gaining initial access, and replace it with a secret code
known only to yourself.
You will mainly use 5 control pushbuttons during the entire
programming process:
- to move one step forward in a menu.
- to move one step backward in a menu.
OKI
- to enter the relevant menu or confirm data.
- to move one level up in a menu.
- to return to the "OK TO EXIT" state.
The sounds you will hear while programming are:
- Single beep, heard whenever a key is pressed.
- Double beep, indicates automatic return to the
normal operating mode (by timeout).

- Happy Melody (- - - –––), indicates successful
completion of an operation.

- Sad Melody (–––––), indicates a wrong move
or rejection.
4.1.2 Entering an Invalid Installer
Code
If you enter an invalid installer code 5 times, the keypad
will be automatically disabled for 90 seconds and the
message WRONG PASSWORD will be displayed.
4.1.3 Installer’s Menu
The installer's menu is shown in figure 4.1a. The text in
rectangles represents the current PowerMaxExpress
display.
4.1.4 Setting a New Installer Code
To set an installer code, perform the actions that are
presented in figure 4.1b. When you are instructed to enter
code, enter a 4-digit code.
4.1.5 Setting a New Installer Code in
PowerMaxExpress that has 2 Installer
Codes
For PowerMaxExpress with 2 installer codes, INSTALLER
code (default 8888) and MASTER INSTALLER code
(default 9999), set new codes as shown in figure 4.1c.
For details regarding the different authorization levels when
logging in with installer code and master installer code, refer
to the note inside figure 4.5C (DEFINE COMM).
By using the master installer code, the menu enables
changing both master installer code and installer code.
By using the installer code, the menu enables changing
the installer code only.
(*) Applicable only when "USER PERMIT" function is enabled
(see par. 4.4.36 - USER PERMIT)
Figure 4.1a - Installer’s Menu
(See fig. 4.1a)
1. NEW INSTL CODE
NEW INST. CODE
INST. CODE xxxx
[code]
Figure 4.1b - Setting a New Installer Code (see note)

Visonic POWERMAXEXPRESS Specifications

General

Brand	Visonic
Model	POWERMAXEXPRESS
Category	Security System
Language	English