38 Elli Charger
EN
Configure Elli Charger Connect and Pro
7.2. Configure the Elli Charger Connect and Pro locally
NOTE: For further information about the configuration, refer to the online manual at
www.elli.eco/download.
PRECONDITION: The wallbox is installed and you have the configuration sticker which
is supplied with the charging station.
1. If the input power to the wallbox is on, have it switched off at the power
supply cabinet. Then have the input power switched on again.
2. The LED indicating the wallbox‘s state shows solid blue and
the Configuration Manager is accessible.
3. Stand close to the wallbox with your mobile device.
4. Connect to the Wi-Fi Hotspot listed on the sticker.
5. Open any internet browser on your mobile device and enter the IP-Address
for the Configuration Page: 192.168.123.4
6. Use the Configuration Page Password shown on the sticker to log in to
the Configuration Manager.
7. Configure the settings of the wallbox according to your requirements:
a. Establish an internet connection for the wallbox, e.g by setting access parameters
to your home Wi-Fi or local area network (LAN).
b. Set your personal preferences, for example: language, log-in password,
use of charge cards for access control.
To Next Page
Loading...
Need help?
General
