42-44
Remove and install complete
When assembling mounting bracket and final drive
carrier away from the vehicle, make sure parts are
correctly located relative to each other.
It is essential that the bonded rubber mounting is
installed stress free in the vehicle.
Fig. 12
Mounting bracket and final drive carrier,
removing and installing
Tightening torque
-A- 45 Nm (33 ft lb)
-B- 65 Nm (48 ft lb)
-C- 85 Nm (63 ft lb)
-D- 85 Nm (63 ft lb)
No specific installation position
Insertion depth: flush with lower edge (arrow)
Fig. 13 Final drive bonded rubber bushing,
pressing in and out
Rear axle, servicing (four wheel drive vehicles)
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.SU01.42.3
To Next Page
Loading...
Need help?
General
