40-57
Fig. 8 Larger clamp, tensioning
- Use pliers VAG 1682 as shown in illustration.
Ensure that the jaws of the pliers seat in the -
-B- of the clamp.
- Tension clamp by turning the spindle with a torque
wrench (do not tilt pliers).
Note:
Fig. 9 Smaller clamp, tensioning 40
The clamp can only be tensioned with pliers
V.A.G 1682.
Tightening torque: 25 Nm (18 ft Ib).
Use torque wrench with 5 - 50 Nm range (e.g.
V.A.G 1331).
Make sure the spindle thread is not tight. If
necessary lubricate with MOS 2 grease
If the thread is tight, e.g. dirty, the required
tensioning force for the hose clamp will not be
achieved inspite of correct tightening torque
settings.
Front Wheel Suspension, Shafts and Axle
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.SU01.40.1
To Next Page
Loading...
Need help?
General
