In case of emergency
Start with auxiliary batteries
WARNING! Ventilate well. Battery gas is
explosive.
WARNING! Never confuse positive and negative
poles on the batteries.
1. Connect red jumper cable to positive pole (+) of
the flat battery, then to the positive pole of the help
start battery.
2. Connect black jumper cable to negative pole (–) of
the help start battery, and then to a place some
distance from the flat batteries, such as the
negative connection on the starter motor.
WARNING! Black jumper cable (–) must not
touch positive connection on the starter motor.
WARNING! Do not touch poles during start
attempt, risk of arcing. Do not bend over the
batteries.
3. Start engine and run at fast idle for ten minutes to
charge the batteries.
4. Stop the engine. Remove the jumper cables in the
reverse order from installation.
60
To Next Page
Loading...
Need help?
General