66
Technical data
Fuel specification
Fuel must comply with national and international standards for commercially supplied fuels, e.g.:
JIS KK 2204. ...................... Type1, Type2, Type3
ASTM, D975 .................................. No.1-D, No.2-D
EN590 ........................... with national environment
and cold requirements
Sulfur content
Complying with legal requirements in each country. If the sulfur content exceeds 0.5 wt%, service intervals must
be changed, (refer to chapter Maintenance lubrication system).
Fuels with low density (urban diesel in Sweden and city diesel in Finland) can result in a loss of power by approx.
5% and an increase in fuel consumption of approx. 2–3 %.
To Next Page
Loading...
Need help?
General