VTech IS 8121-3 User Manual

58
NOTES
• The pairing process may take up to
one minute. If the pairing process
fails, try again.
• The steps for the pairing process
may vary for different cell phones.
If this happens, follow the prompts
on your cell phone and your IS8121/
IS8121-2/IS8121-3/IS8121-4/IS8121-5
to complete the pairing process.
• Refer to the user’s manual of your cell
phone on how to search for or add a
new Bluetooth device.
Add a Bluetooth headset
Before you begin, make sure that
your Bluetooth enabled headset is
not connected to any other Bluetooth
device. Refer to your headset user’s
manual to learn how to search for or add
new Bluetooth devices.
Pair and connect a headset
1. Press MENU/SELECT on the handset
in idle mode.
2. Press q CID or p to highlight
Bluetooth, then press MENU/SELECT.
3. Press q CID or p to highlight
Add BT headset, then press
MENU/SELECT.
• The display shows Search
headset...
4. Set your headset to discoverable
mode (refer to the user’s manual
of your headset). When the screen
displays the found devices, press
q CID or p to highlight your
headset, if necessary, then press
MENU/SELECT.
NOTES
• The pairing process may take up to
one minute. If the pairing process
fails, try again.
• When a connected headset is
charging, it may disconnect from the
telephone base and the CELL 2 light
on the telephone base turns off. For
some headset models, you may need
to turn on the headset and reconnect
it to the telephone base again.
Device list and connection
Up to two devices can be paired to the
telephone base. All paired devices are
shown on the device list. To use a paired
device, it must be connected and in an
active slot (1: or 2:) on the device list.
Only one active device can be on a call
at a time.
Once you have paired a device with
the telephone base, you do not need
to repeat the pairing procedure again
unless you delete the device from the
device list.
NOTE
• When connecting a Bluetooth device
to the device list, all connected devices
will be temporarily disconnected until
the procedure is complete. It may take
up to two minutes to reconnect.

VTech IS 8121-3 Specifications

General

Brand	VTech
Model	IS 8121-3
Category	Telephone
Language	English