60
Register a handset
When your handset is deregistered from the telephone base,
follow the steps below to register it back to the telephone
base.
Method 1:
1. Before you begin registration, make sure the handset is out
of the telephone base or charger and shows To register
HS, see manual..
2. Put the handset you wish to register on the telephone base
cradle.
3. The handset shows Registering... Please wait. If the
registration is successful, both the handset and the
telephone base screens display HANDSET X Registered
(HANDSET represents the handset name, X represents the
handset number). Both the handset and the telephone
base beep. The handset is now registered with the
telephone base.
If registration fails, the system will automatically try to register
again. If registration fails after the third try, Registration failed
appears on both screens. The handset shows To register HS,
see manual. and the telephone base returns to idle mode. This
may take up to five minutes to occur. Please start again from
Step 1.
Method 2:
1. Press and hold FIND HS on the telephone base for about
four seconds and it shows Registering... Please wait.
2. Press QUIET # on the handset. The handset shows
Registering... Please wait. If the registration is successful,
both the handset and the telephone base screens display
HANDSET X Registered (HANDSET represents the handset
name, X represents the handset number). Both the
handset and the telephone base beep. The handset is now
registered with the telephone base.
If registration fails, Registration failed appears on both screens.
The handset shows To register HS, see manual. and the
telephone base returns to idle mode. This may take up to five
minutes to occur. Please start again from Step 1.
Screen messages
Added to
allow list
The telephone has just added an
entry to the allow list.
Added to
block list
The telephone has just added an
entry to the block list.
Added to
star name list
The telephone has just added an
entry to the star name list.
Activating
remote voice
control...
The telephone is activating remote
voice control.
BASE 0
is calling
The telephone base is calling.
BASE 0
is calling all
The telephone base is calling all
devices (for intercom calls).
Block list
is empty
There are no call block entries.
Blocked call
An incoming call was blocked.
Blocking
call...
The Smart call blocker feature of the
telephone is rejecting a call with
block announcement.
Bluetooth
system busy
You are trying to make a cell call or
access the Bluetooth menu when
the Bluetooth link is already being
used.
Call
transferred
You have transferred an outside call
to another device.
Caller ID log
empty
There are no entries in the caller ID
log.
Calling
BASE 0
The handset is calling the telephone
base (for intercom calls).
Calling
HANDSET X
The handset or telephone base is
calling another handset (for
intercom calls).
The telephone base is transferring
an outside call to a handset.
Cell
The cell line is on a call.
Cell call on hold
A call on the cell line has been put
on hold.
Cell line in use
Another system handset is using the
cell line.
Cell 1/2 alert:
XXX
The Android phone that you paired
with this telephone received a
mobile notification.
Cell 1/2 low batt
Message received from Alerts
manager that your cell phone’s
battery is low.
Connection failed
A Bluetooth device failed to
establish a connection with your
telephone system.
Connection
timeout.
Please check
cell status.
The telephone has failed to activate
remote voice control.
Contact deleted
A phonebook entry is deleted.
To Next Page
Loading...
Need help?
General
