Mount the baby unit on dry wall (optional)
Items to purchase
You will need to purchase the following items separately to mount your baby unit:
Note
The types of screws and anchors you need depend on the composition of the wall.
(1)
Note
Check for reception strength and camera angle before drilling the holes.
Use a pencil to mark two holes in parallel. Make sure they are the same distance apart as the wall mount holes
on the baby unit.
(2)
Drill two holes in the wall ( 7/23 inch drill bit ). If you drill the holes into a stud, go to step 3.
-OR-
If you drill the holes into an object other than a stud, insert the wall anchors into the holes. Tap gently on the ends
with a hammer until the wall anchors are flush with the wall.
To Next Page
Loading...
Need help?
General
