9 Use and operation
100_0201_op_0005.fm 23
1. Hold the machine at the guidance clip.
2. Open fuel cock.
3. Set gas regulating lever to SLOW.
4. Pull the starter rope several times until the engine starts.
5. Allow the engine to warm up.
6. The machine starts and vibration works in the forward direction.
9.4 Operation
Guide and steer the machine only at the guide clip.
9.4.1 Compacting material
1. Guide the machine with both hands on the guidance clip.
2. Operate the gas regulating lever until the desired speed is reached.
3. If the material is compressed, lift and reset the machine.
When lifting the machine, set the gas regulating lever to NO LOAD, so that the engine continues
to run at a low speed.
Item Designation Item Designation
1 Gas regulating lever 3 Reversing starter
2Fuel cock
WARNING
Injuries due to an uncontrolled machine.
Always hold the machine with both hands and in a firm position.
To Next Page
Loading...
Need help?
General
