38
Maintenance EHB 11
8.2 Maintenance work
Work in the workshop
Perform maintenance work in a workshop on a workbench. This has the following
benefits:
Protection of the machine of contamination on the construction site.
A level and clean work surface makes work easier.
There is a better overview over small parts and they are not lost as easily.
Cleaning the machine
1. Clean the ventilation slots with a suitable tool.
2. Wipe the housing with a damp and clean cloth.
3. Free tool of dirt using suitable tools.
Lubricating the crank mechanism
Only use special lubricants for lubricating.
For further information, refer to chapter Technical Data.
1. Place filled grease gun onto the zerk fitting and operate 5 to 6 times.
2. Wipe off zerk fitting with a clean cloth.
WARNING
Electrical voltage.
Injuries from electrocution.
f Remove the plug from the plug receptacle before all work on the machine.
Item Designation
1 Zerk fitting
To Next Page
Loading...
Need help?
General
