HC920•HC940•HC960 33
Safety regulations General view of application
U Installing the unit (gasoline units)
Danger
Use the Airless spraying unit with a gasoline engine,
preferably outdoors.
Take the wind direction into account. Then place
the unit so that no vapors containing solvents are
deposited in the area of the unit.
Observe a minimum distance of 3 m between the
unit with gasoline engine and the spray gun.
Observe a minimum distance of 3 m between the unit with
gasoline engine and the spray gun.
U Using unit on construction sites
(electric units)
Connection to the mains only through a special feed point, e.g.
through an error protection insallation with INF < 30 mA
U Ventilation when spraying in rooms
Adequate ventilation must be guaranteed in order to remove the
solvent vapors and the exhaust fumes of the gasoline engine.
U Suctions installations
These are to be set-up by the user of the unit according to local
regulations.
U Earthing of the object
The object to be coated must be earthed.
U Cleaning the unit with solvents
When cleaning the unit with solvents, the solvent
should never be sprayed or pumped back into a
container with a small opening (bunghole). An
explosive gas/air mixture can arise. The container
must be earthed.
U Cleaning the unit
Danger of short-circuits caused by water
ingressing into the electrical equipment of the
gasoline engine.
Never spray down the unit with high-pressure or
high-pressure steam cleaners.
U Work or repairs on the electrical
equipment
Onlyhavethisworkcarriedoutbyaqualiedelectrician.No
liability will be taken for incorrect installation.
U Working on electrical components
Remove the power cord from the socket during all repair
work.
U Setting-up on uneven surfaces
The front side of the unit must point downwards to prevent sliding
away.
2. General view of application
2.1 Application
Primingandnalcoatingoflargeareas,sealing,impregnation,
construction sanitation, façade protection and renovation, rust
protection and building protection, roof coating, roof sealing,
concrete sanitation, as well as heavy corrosion protection.
Examples of objects to be sprayed
Large-scale construction sites, underground construction, cooling
towers, bridges, sewage treatment plants and terraces.
Generally for the whole building protection where operation
without electric power is required.
To Next Page
Loading...
Need help?
General
