Operation
en
Sun-switch (heating)
The sun-switch shuts down the device automatically, if the temperature rises above
therequestedtemperature,forexample,duetosunlight.Thetemperaturemust
rise by +7 °C above the set value for a half an hour. If the device has been shut
down by the sun-switch, an indicator light (5) blinks on the thermostat. The sun-
switch can be turned off temporarily, by turning the temperature control (2).
A heater that has been shut down can be restarted manually, if necessary.
Temperature of cabin can be determined by turning the knob (2) until the bright-
ness of the thermostat light (5) changes. The position of knob (2) when the light
changes will indicate cabin temperature.
Manual power adjustment (stove/heating)
The power can be adjusted manually.
Toenablethisfunction,turnthepoweradjuster(2)topositionsmin-max-min–
max.
The device signals that manual function has been activated when the thermostat
light (5) shuts off.
After the heater has been started up, the power can be adjusted smoothly with the
power adjustment knob (2).
From manual mode to thermostat mode you can go by turning the knob (2) min -
max-min–maxagain.Asaconrmationofmodechangethethermostatlight(5)
will go on
Shutdown
You can shut down the heater by pressing the heating switch (3) continuously for at
least 2 seconds. The yellow heating indicator light (7) will go out immediately. The
redcombustionindicatorlight(1)willcontinuetoblinkforaboutveminutes,while
the device is cooling down. You cannot restart the device until the combustion light
has stopped blinking.
When adjusting the effect from the regulation knob, the effect adjusts
smoothly.
The total time of the starting procedure is app. 11 minutes, when after
the device can be adjusted or will set itself to the selected effect.
Only use the heater when the vehicle is at a standstill and never when
it is unattended.
D30101D
- 65 -
To Next Page
Loading...
Need help?
General
