Instructions for Assembly
Item number 116523-0000
We reserve the right to make technical
changes
Version 4 01.04.2014 Page 29/49
Opal Design II / Opal Design II LED
4.
Mount the jockey cover
1. Extend the drop profile until it is
approx. 1 metre open.
2. Attach the bracket plate (2) to
the pre-assembled jockey cover
holder (1) from the inside.
3. Prepare the barrel arbour and
fabric: To do this, remove the
protective strip from the double-
sided sticky tape and affix the
fabric to the middle of the barrel
arbour.
Make sure that the sticky tape does not hang over the sides. Remove any overhanging
sticky tape.
4. Wind the fabric around the barrel
arbour.
The fabric must always be centred and straight when wound around the shaft. If
necessary, use rubber seals to prevent the fabric from rolling off. These will help to keep
the right tension.
To Next Page
Loading...
Need help?
General
