Instructions for Assembly
Item number 116523-0000
We reserve the right to make technical
changes
Version 4 01.04.2014 Page 30/49
Opal Design II / Opal Design II LED
5. Slide the jockey cover holder into
position. Now affix the right-hand
side to the bottom profile.
6. Clamp the barrel arbour with
jockey cover between the jockey
cover holder so that it is centred.
To align, loosen the the clamping
screws on the bottom section of
the cassette if necessary.
7. The barrel arbour and fabric
must be pretensioned. This will
require turning the barrel arbour
and fabric 8 times around its own
axis in an anti-clockwise
direction (see red sticker on
barrel arbour).
8. Pull the fabric by the fabric rail as
far as the drop profile.
9. Insert the fabric rail and cord
edge from the side into the slot
on the coupling profile.
10. Then open and retract the
awning once. As you do this,
check how the jockey cover
winds the fabric and slightly
adjust the fabric on the coupling
profile if necessary.
11. Once the ideal winding
performance has been found,
affix the jockey cover to the
coupling profile using dowels and
screws.
To Next Page
Loading...
Need help?
General
