4. Touch OK.
5. Do one of the following:
• To continue in Advanced settings, touch another tab.
• To exit Advanced settings and return to the Home tab, touch Exit.
Review the open source software disclosure
1. In Advanced settings, touch the General > Open Source tabs.
2. Read Welch Allyn's disclosure about its use of "free" or "open source" software.
3. Do one of the following:
• To continue in Advanced settings, touch another tab.
• To exit Advanced settings and return to the Home tab, touch Exit.
Parameters tab
Specify advanced NIBP settings
1. In Advanced settings, touch the Parameters > NIBP tabs.
2. Specify settings.
Setting Action/Description
Default view Select default primary and secondary views.
Unit of measure Select the NIBP unit of measure for display.
Tube type Select the number of tubes that are connected to the
NIBP cuff that is used with this monitor. If you select 1
tube, the device sets the algorithm to Step,
disabling other options.
Algorithm default Select the default algorithm used to determine NIBP
measurements.
Cuff inflation target Enter a default cuff inflation pressure for each type of
patient.
3. Do one of the following:
• To continue in Advanced settings, touch another tab.
• To exit Advanced settings and return to the Home tab, touch Exit.
Specify advanced temperature settings
1. In Advanced settings, touch the Parameters > Temperature tabs.
2. Specify settings.
Setting Action/Description
Unit of measure Select primary units of measure for the temperature
display on the Home tab
Display temperature conversion Enable to display primary units of measure and
secondary units of measure for the temperature display
on the Home tab.
3. Do one of the following:
• To continue in Advanced settings, touch another tab.
Service manual Advanced settings 25
To Next Page
Loading...
Need help?
General
