To Next Page

To Previous Page

The Select existing package field displays the path to the waclientcert.pim file.

10. Click Load Network Policy Server Certificate.

A message box displays the installation progress. The process should take a

maximum of three minutes.

11. If the message box displays for more than six minutes, begin the process again from

step 1.

12. If the message box displays a message indicating the installation is successful, click

OK.

13. Close the WAST application.

14. Disconnect the USB connection.

15. Restart the CSM.

You can now configure the CSM to use certificates on the wireless network.

Verify the certificate is loaded to the device

There is no on-screen verification that a certificate has been loaded to the device.

1. Reset the radio settings of the device to factory default.

2. Restart the device.

3. Configure the following network settings:

Setting Description

> Radio > Enabled

> Authentication Type > WPA2 Enterprise

4. Configure the network settings for the certificate you are verifying:

• If you are verifying that a CA certificate is loaded:

EAP Type: PEAP-MSCHAPv2

Enable Server Validation: Checked

• If you are verifying that a client certificate is loaded:

EAP Type: EAP-TLS

Enable Server Validation: Unchecked

If the error for Invalid Configuration 350018 appears, the certificate is not loaded.

Wireless radio technology Connex

Spot Monitor

Welch Allyn Connex Spot Monitor Service Manual

Other manuals for Welch Allyn Connex Spot Monitor