Welch Allyn LS200 Procedure Light User Manual

CAUTION: DISCONNECT LS200 FROM POWER SOURCE BEFORE SERVICING.
A BEZEL ASSEMBLY (R & R) PN 441145-501
CAUTION: ALLOW HOT LAMPS TO COOL FOR 20 MINUTES BEFORE REMOVING
BEZEL.
A 1. UNPLUG LS200 AND REMOVE HANDLE.
(ALSO REFER TO OPERATING INSTRUCTIONS PN 441118-1ML.)
REMOVE POWER CORD FROM A.C. POWER SOURCE. LAY LS200 DOWN
WITH HANDLE FACING UP. UNSCREW THE HANDLE COUNTER
CLOCKWISE. REMOVE HANDLE. UNSCREW THE TETHER RETAINING
NUT AND REMOVE THE TETHER.
A 2. REMOVE BEZEL.
SLIDE THE BEZEL OFF OF THE THREADED ROD.
A 3. REPLACE BEZEL.
INSPECT LAMPS, REFLECTORS, SHROUD, BEZEL, AND GLASS FOR
SMUDGES, AND DUST. CLEAN BEFORE REASSEMBLING. DO NOT USE
SOLVENTS TO CLEAN BEZEL. PUT BEZEL OVER LIGHT HOUSING
WITH THREE TABS OVER THREE RECESSES IN THE LAMP HOUSING.
ALIGN TABS ON BEZEL WITH TABS ON LAMP HOUSING. PLACE THE
TETHER ONTO THE THREADED ROD OF THE CENTRAL BRACE.
THREAD THE NUT ONTO THE THREADED ROD AND TIGHTEN HAND
TIGHT. THREAD THE HANDLE ONTO THE THREADED ROD UNTIL IT
CONTACTS THE BEZEL. TIGHTEN THE HANDLE SLIGHTLY UNTIL THE
BEZEL IS FIRMLY IN PLACE.
A 4. VERIFY REPAIR.
PLUG LS200 INTO MAINS AND TURN SWITCH TO ON POSITION.
ALL THREE LAMPS SHOULD BE LIT. TURN OFF. ALL LAMPS MUST
TURN OFF.
T E C H N I C I A N N O T E S :
____________________________________________________________________________
____________________________________________________________________________
____________________________________________________________________________
____________________________________________________________________________
____________________________________________________________________________
____________________________________________________________________________
13

Welch Allyn LS200 Procedure Light Specifications

General

Brand	Welch Allyn
Model	LS200 Procedure Light
Category	Lighting Equipment
Language	English