CAUTION: DISCONNECT LS200 FROM POWER BEFORE SERVICING.
I YOKE R & R
I 1. REMOVE LAMP HOUSING.
REFER TO SECTION H-1, H-4, AND H-5 ON PAGE 20, BUT LEAVE TWO
RED WIRES ATTACHED TO THE SWITCH SINCE IT IS NOT BEING
REMOVED.
I 2. REMOVE LOWER ARM.
REMOVE TWO FLAT HEAD PHILLIPS SCREWS NEAREST JOINT #3
(ADJUSTABLE JOINT), AND SLIDE LOWER ARM OFF OF HINGE BRACKET.
I 3. REMOVE STRAP FROM HINGE BRACKET.
UNSCREW 3/8" NUT FROM STUD. USE SLIP JOINT PLIERS TO PULL
AND LIFT STRAP FROM STUD. (THIS WILL RELIEVE TENSION ON 2
YOKE SCREWS AND PERMITS DISASSEMBLY OF SPRING BRACKET
FROM YOKE STUD.)
I 4. REMOVE STRAIN RELIEF.
COMPRESS STRAIN RELIEF WITH HEYCO TOOL AND REMOVE STRAIN
RELIEF FROM LONG ARM.
I 5. UNSCREW YOKE SET SCREW AT JOINT #2.
USE FLAT BLADE SCREWDRIVER TO UNSCREW YOKE SET SCREW.
I 6. REMOVE YOKE FROM JOINT #2.
UNSCREW TWO FLAT HEAD PHILLIPS SCREWS FROM UPPER ARM AT
YOKE JOINT. WHILE FEEDING CABLE BACK OUT OF YOKE, PULL
YOKE OUT OF JOINT #2. WHEN CONNECTOR PLATE IS ACCESSIBLE,
REMOVE IT FROM CONNECTOR BLOCK/YOKE STUD ASSEMBLY.
TWO FLAT SPRINGS, BRAKE MATERIAL, AND NYLINERS WILL COME
OUT OF CONNECTOR BLOCK. REMOVE END CAPS.
I 7. REMOVE CABLE FROM YOKE.
GENTLY PULL WIRES OUT OF YOKE. DISCARD YOKE.
I 8. ASSEMBLE CONNECTOR BLOCK TO END OF NEW YOKE.
SNAP ONE OF THE END CAPS ONTO THE YOKE. PLACE A SECOND
END CAP ONTO STUD FACING OTHER END CAP. INSERT NYLINERS
TO EACH END OF CONNECTOR BLOCK BORE. FEED THE BLACK/
WHITE WIRES THROUGH STUD INTO YOKE. PLACE THE STUD
PORTION OF THE YOKE INTO THE CONNECTOR BLOCK.
I 9. PLACE THE STRAP/SPRING CONNECTOR PLATE ASSEMBLY ONTO THE
CONNECTOR BLOCK/YOKE ASSEMBLY. PLACE THE BRAKE
MATERIAL AND TWO FLAT SPRINGS (CURVED SIDE UP) INTO THE
OPENING IN THE CONNECTOR BLOCK. POSITION THE CONNECTOR
PLATE OVER THE CONNECTOR BLOCK/YOKE STUD ASSEMBLY WITH
THE ROTATIONAL STOP OF THE STUD ENGAGED WITH THE
CONNECTOR PLATE.
22
To Next Page
Loading...
Need help?
General
