CAUTION: DISCONNECT LS200 FROM POWER SOURCE BEFORE SERVICING.
M MOBILE STAND DISASSEMBLY / ASSEMBLY.
M 1. CASTERS
PRY THE CASTERS OUT USING TOOL DESIGNED FOR 486 MOBILE STAND.
M 2. POLE REMOVAL.
UNSCREW THE HEX-HEAD SCREW UNDER THE BASE.
M 3. BASE LEGS.
UNSCREW TWO CAP SCREWS AT EACH END OF THE BASE.
****
N WALL MOUNT DISASSEMBLY. (REFER TO DRAWING #441007)
N 1. REMOVE MOUNT BRACKET FROM WALL PLATE.
REMOVE FOUR SCREWS AND REMOVE BRACKET FROM PLATE.
N 2. REMOVE CLAMP BUSHING BOTTOM OF MOUNT BRACKET.
REMOVE SET SCREW FROM ASSEMBLY. THIS SCREW WAS INSTALLED
WITH LOCTITE. REMOVE THREE HEX HEAD CAP SCREWS FROM CLAMP
BUSHING AND REMOVE.
N 3. REMOVE PIN AND WASHERS.
TAP OUT PIN. SPRING WASHERS, BUSHINGS WILL COME OUT.
REASSEMBLE WALL MOUNT. (SEE DRAWING #441014)
N. 4. INSTALL WASHERS AND NYLINER.
PLACE NYLINERS INTO THE MOUNT BRACKET. PLACE A NYLON
WASHER OVER THE NYLINER, THEN TWO SPRING WASHERS,
CONVEX SIDES TOGETHER, AND ANOTHER NYLON WASHER.
N 5. INSTALL PIN.
SLIDE THE MOUNT ARM INTO THE ASSEMBLY AND INSERT A NYLON
WASHER BETWEEN THE ARM AND BRACKET. PLACE THE CLAMP
BUSHING AND ANOTHER NYLINER INTO THE MOUNT BRACKET
ASSEMBLY AND LINE UP HOLES. DROP A PIN INTO THE ASSEMBLY
WITH THE MOUNT ARM PERPENDICULAR TO THE MOUNT BRACKET.
N 6. SECURE ARM WITH SET SCREW.
SECURE WITH THREE SCREWS TIGHTENED TO 18 IN-LBS. MINIMUM.
LINE UP THE BOSS ON THE PIN WITH THE LENGTHWISE AXIS OF THE
ARM. PLACE LOCTITE ONTO THE THREADS OF THE SET SCREW AND
INSERT IT INTO THE THREADED HOLE ON THE END OF THE ARM.
TIGHTEN THE SET SCREW TO 18 IN-LBS. MINIMUM.
30
To Next Page
Loading...
Need help?
General
