Welch Allyn LS200 Procedure Light User Manual

CAUTION: DISCONNECT LS200 FROM POWER SOURCE BEFORE SERVICING.
E POWER SWITCH R & R
NOTE: IT IS NOT NECESSARY TO DISASSEMBLE THE LAMP HOUSING TO
REPLACE THE SWITCH.
E 1. REMOVE SWITCH.
APPLY A SMALL PIECE OF MASKING TAPE TO THE LAMP HOUSING
ALONG THE EDGES OF THE SWITCH TO PROTECT THE SURFACE
FINISH OF HOUSING DURING SWITCH REMOVAL. PULL THE OLD
SWITCH OUT OF THE LIGHT HOUSING BY PRYING UPWARDS AT THE
END OF THE SWITCH WITH A THIN EDGE SUCH AS A PUTTY KNIFE.
E 2. DISCONNECT WIRES FROM SWITCH.
UNPLUG ALL FOUR (4) WIRES FROM THE BOTTOM OF THE SWITCH.
E 3. INSTALL NEW SWITCH.
ATTACH WIRES AND PRESS SWITCH INTO LAMP HOUSING, MAKING
SURE THAT THE LAMP SYMBOL ON THE TOP OF THE SWITCH IS
TOWARDS THE WORD “WELCH” OF THE WELCH ALLYN NAME ON
THE FRONT OF THE HOUSING. THESE WIRES CONDUCT A.C.
CURRENT AND AS SUCH MAY BE ATTACHED TO THE SWITCH IN
EITHER POSITION. REFER TO ASSEMBLY DRAWING NO. 441013.
E 4. VERIFY REPAIR.
CONNECT LS200 TO POWER SOURCE AND OPERATE THE SWITCH
APPROXIMATELY 5 TIMES TO DETERMINE THAT THE SWITCH IS
OPERATING PROPERLY. VERIFY THAT ALL THREE LAMPS LIGHT.
T E C H N I C I A N N O T E S :
____________________________________________________________________________
____________________________________________________________________________
____________________________________________________________________________
____________________________________________________________________________
____________________________________________________________________________
____________________________________________________________________________
____________________________________________________________________________
17

Welch Allyn LS200 Procedure Light Specifications

General

Brand	Welch Allyn
Model	LS200 Procedure Light
Category	Lighting Equipment
Language	English