Operation | 6 | English
Operating instructions PT Series | 89014547; 2021-03 | 41
6.5 Soaking programme
We recommend the soaking programme for soaking and dissolving dried-on residues.
Activate soaking programme
Start soaking programme
Danger
Risk of chemical burns due to chemicals
Contact between chemicals with the skin or eyes can lead to severe burns or serious eye damage.
Ø In the event of contact with the eyes or skin, rinse thoroughly with tap water. Seek medical attention as
required.
Ø Wear protective clothing, protective gloves and protective goggles.
Ø Observe the danger and safety notes on the canister and safety data sheet.
Ø Only remove the wash items when the washing programme has finished and the start button flashes green.
Five seconds after the soaking programme has started, the wash pump circulates the tank water for seven seconds. The
soaking time of five minutes begins after this circulation. The tank water moistens the wash items and soaks the contam-
inants.
– If you open the hood during this time and close it again within 10 seconds, the wash pump circulates the tank water
again for five seconds. The soaking time is not extended.
– If you open the hood for longer than 10 seconds to put more wash items in the washing basket, the soaking pro-
gramme will start from the beginning once the hood has been closed. A washing programme starts automatically after
the end of the soaking period. The soaking period can also be shortened by pressing the start button.
A service technician can adjust the times mentioned above.
Terminate soaking programme
After terminating the soaking programme, always start a washing programme to rinse the tank water off the wash items.
To Next Page
Loading...
Need help?
General
