Xerox 2400 Series User Manual

Xerox Scanner User’s Guide 65
Scanning
5. Click the Scan button on the TWAIN Interface.
6. Your document will be scanned and sent to the Destination
Application specified in the One Touch 4.0 Properties window.
In the example shown on the previous page, the Destination
Application is PaperPort.
To Scan Multiple Pages
You can use Configure Before Scan to create multi-page
documents from individually scanned pages.
To scan multiple pages:
1. Put the page on the Flatbed Glass and close the lid.
2. When the TWAIN Interface opens, select the appropriate scan
settings for your document.
3. Click the Scan button on the TWAIN Interface.
4. After the Scanning Progress bar closes, place the next page on
the Flatbed Glass, close the lid, and click the Scan button
again.
5. Continue until you have scanned all the pages in your multi-
page document.
6. When you’re finished scanning, click the Done button on the
TWAIN Interface.
7. All the scanned pages will be sent to the Destination
Application set in the One Touch 4.0 Properties window. If the
Destination Application is PaperPort, the pages will be grouped
as a single stack of pages.
NOTE: Using the Configure Before Scan option to scan multiple
pages does not apply for page formats BMP and JPG. Please
make sure the Configure Before Scan page format on the One
Touch 4.0 Properties window is set to TIFF, PDF, or one of the
Text formats.

Xerox 2400 Series Specifications

General

Brand	Xerox
Model	2400 Series
Category	Scanner
Language	English