Xerox Phaser 6120 User Manual

Status, Error, and Service Messages130
PAPER SIZE MISMATCH
When using Tray 1:
The paper size set from
the printer driver is
different from the size of
paper loaded into Tray 1.
This message appears
when
PAPER MENU/
INPUT TRAY/TRAY
1 MODE
is set to AUTO.
Printing continues with
paper of a different size,
even if this message
appeared.
To print using paper of
the desired size, load
paper of the correct size,
and then try printing
again.
When using Tray 2:
The paper size set from
the printer driver is
different from the size of
paper loaded into Tray 2.
This message appears
when PAPER MENU/
INPUT TRAY/AUTO
CONTINUE
is set to ON.
X TONER LOW
The X toner cartridge is
low and should
be
replaced within 200
pages at 5% coverage of
letter/A4 pages.
Replace the specified
toner cartridge soon.
Be
sure to have a toner
cartridge on hand
TRAY 2 OPEN
Tray 2 is not installed or
is not fully closed.
Close Tray 2 or print
from another tray.
This message... means... do this...

Xerox Phaser 6120 Specifications

General

Color	Yes
Print technology	Laser
Time to first page (black, normal)	13 s
Time to first page (color, normal)	22 s
Print speed (black, normal quality, A4/US Letter)	20 ppm
Print speed (color, normal quality, A4/US Letter)	5 ppm
Internal memory	128 MB
Processor model	300 MHz, 32 bit RISC
Maximum print size	210 x 297 mm
Maximum ISO A-series paper size	A4
I/O ports	USB
Power requirements	200 – 240 VAC / 100 – 127 VAC 50/60 Hz
Networking features	Ethernet/Fast-Ethernet
Non-operating relative humidity (non-condensing)	10 - 85 %
Total input capacity	200 sheets
Maximum input capacity	500 sheets
Printer fonts	PostScript
Maximum duty cycle	35000 pages per month
Number of PostScript fonts	139
Power consumption (printing)	380 W
Storage temperature (T-T)	-20 - 40 °C
Operating temperature (T-T)	10 - 32 °C
Operating relative humidity (H-H)	10 - 80 %

Weight and Dimensions

Dimensions (WxDxH)	442 x 395 x 341 mm