User Safety Summary
153
Operational Safety
Your printer and supplies were designed and tested to meet strict safety
requirements. These include safety agency examination, approval, and
compliance with established environmental standards.
Your attention to the following safety guidelines helps to ensure the
continued, safe operation of your printer.
Printing Safety Guidelines
Wait 10-15 seconds between turning the printer off and on.
Keep hands, hair, neckties, etc., away from the exit and feed rollers.
When the printer is printing:
Do not remove the paper source tray that you selected in either the
printer driver or control panel.
Do not open the doors.
Do not move the printer.
Operational Guidelines
Do not block or cover the slots and openings on the printer. The printer
may overheat without adequate ventilation.
Do not place the printer near a heat source.
Do not place the printer in direct sunlight to avoid exposing light-sensitive
components when the doors are open.
Do not place the printer in line with the cold air flow from an air
conditioning system.
Place the printer on a level, solid non-vibrating surface with adequate
strength for the weight of the printer. It should be within 2° of horizontal
with all four feet in solid contact with the surface. The base printer weight
without any packaging materials is approximately 20.5 kg (45 lb.).
For optimum performance, use the printer at elevations below 2,500 m
(8,200 ft.).
Printer Clearance
Place the printer in an area where there is adequate space for ventilation,
operation, and servicing. For information about the printer clearance, see
“Getting Acquainted with Your Printer” on page 2.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
