Xerox Phaser 6120 User Manual

Dual In-Line Memory Module (DIMM)
137
Dual In-Line Memory Module (DIMM)
" You may need additional memory (DIMM) for complex graphics and
for duplex printing.
A dual in-line memory module (or DIMM) is a compact circuit board with
surface-mount memory chips.
Your printer comes with 128 MB SDRAM printer memory on board. However,
you can upgrade to a maximum of 640 MB of RAM through the installation of
an additional unbuffered SDRAM DIMM. Your printer comes with one free
DIMM slot.
Installing a DIMM
CAUTION
It’s very important to protect the printer controller board and any associated
circuit boards from electrostatic damage. Before performing this procedure,
review the antistatic caution on
Page 136. In addition, always handle circuit
boards by the edges only.
1 Turn off the printer and disconnect the power cord and interface cables.
" If the duplex unit is installed, remove it.

Xerox Phaser 6120 Specifications

General

Color	Yes
Print technology	Laser
Time to first page (black, normal)	13 s
Time to first page (color, normal)	22 s
Print speed (black, normal quality, A4/US Letter)	20 ppm
Print speed (color, normal quality, A4/US Letter)	5 ppm
Internal memory	128 MB
Processor model	300 MHz, 32 bit RISC
Maximum print size	210 x 297 mm
Maximum ISO A-series paper size	A4
I/O ports	USB
Power requirements	200 – 240 VAC / 100 – 127 VAC 50/60 Hz
Networking features	Ethernet/Fast-Ethernet
Non-operating relative humidity (non-condensing)	10 - 85 %
Total input capacity	200 sheets
Maximum input capacity	500 sheets
Printer fonts	PostScript
Maximum duty cycle	35000 pages per month
Number of PostScript fonts	139
Power consumption (printing)	380 W
Storage temperature (T-T)	-20 - 40 °C
Operating temperature (T-T)	10 - 32 °C
Operating relative humidity (H-H)	10 - 80 %

Weight and Dimensions

Dimensions (WxDxH)	442 x 395 x 341 mm