Xerox Phaser 6120 User Manual

Replacing Consumables
79
Replacing a Toner Cartridge
Note:
Be careful not to spill toner while replacing a toner cartridge. If toner
spills, immediately wipe it off with a soft, dry cloth.
If TONER OUT ACTION on the QUALITY/TONER OUT ACTION menu
is set to
STOP, the message REPLACE X TONER (where "X" represents
the color of the toner) appears when a toner cartridge becomes empty. Follow
the steps below to replace the toner cartridge.
" If TONER OUT ACTION on the QUALITY/TONER OUT ACTION
menu is set to CONTINUE, the message X EMPTY appears.
1 Check the message window to see which color of toner is empty.
Perform the operation described below to automatically rotate the
carousel to move the toner cartridge for the specified color, so that it can
be replaced.
Press Key Until Display Reads
REPLACE X TONER or X EMPTY
MENU
PRINTABLE PAGES MENU
If the hard disk drive is installed, the
PROOF/PRINT MENU appears.
× 2 (or × 3)
MENU
QUALITY MENU
TONER REMOVAL
BLACK
Press until appropriate
color (X) is displayed.
X

Xerox Phaser 6120 Specifications

General

Color	Yes
Print technology	Laser
Time to first page (black, normal)	13 s
Time to first page (color, normal)	22 s
Print speed (black, normal quality, A4/US Letter)	20 ppm
Print speed (color, normal quality, A4/US Letter)	5 ppm
Internal memory	128 MB
Processor model	300 MHz, 32 bit RISC
Maximum print size	210 x 297 mm
Maximum ISO A-series paper size	A4
I/O ports	USB
Power requirements	200 – 240 VAC / 100 – 127 VAC 50/60 Hz
Networking features	Ethernet/Fast-Ethernet
Non-operating relative humidity (non-condensing)	10 - 85 %
Total input capacity	200 sheets
Maximum input capacity	500 sheets
Printer fonts	PostScript
Maximum duty cycle	35000 pages per month
Number of PostScript fonts	139
Power consumption (printing)	380 W
Storage temperature (T-T)	-20 - 40 °C
Operating temperature (T-T)	10 - 32 °C
Operating relative humidity (H-H)	10 - 80 %

Weight and Dimensions

Dimensions (WxDxH)	442 x 395 x 341 mm