Xerox Phaser 7300 Features Guide

Printer Features
Phaser® 7300 Color Printer 23
Power saver
The printer enters a Power Saver low-energy consumption mode after a predefined period of time since
its last activity. In this mode, most printer electrical systems are shut down. When a print job is sent to
the printer, it wakes up the printer in less than a minute. You can also wake the printer by pressing the
OK key on the front panel.
If you find that the printer is going into Power Saver mode too often and you do not want to wait while
the printer wakes up, you can extend the length of time before the printer goes into Power Saver mode.
Change the timeout on the front panel as follows:
1. With
Menus highlighted, press the OK key.
2. Scroll through the menu to
Printer Setup Menu using the Down Arrow key and press the
OK key.
3. Scroll through the menu to
Set Power Saver Timeout using the Down Arrow key and
press the OK key.
4. Select a Power Saver timeout value. Select a higher value if you want to extend the length of time
before the printer goes into Power Saver mode.
5. Press the OK key.
To turn off the Power Saver feature, use the following procedure:
1. With
Menus highlighted, press the OK key.
2. Scroll through the menu to the
Printer Setup Menu and press the OK key.
3. Scroll to the
Reset Printer Menu using the Down Arrow key and press the OK key.
4. Scroll through the menu to
Power Saver using the Down Arrow key.
5. Press the OK key to turn off.
Protected mode for the front panel menus
You can put the printer into “protected mode” to prevent users from changing printer settings that may
impact the prints of other users from the front panel. Instead, users can select printing features, such as
color corrections, through the printer drivers only. In protected mode, users can access general menus
that can improve their print quality and direct them to user features, while locking the menus and items
in menus that the system administrator uses to manage the printer.
To enter or exit protected mode, use CentreWare IS software:
1. From your printer’s Internet Services home page, click Properties.
2. On the left side of the Properties page in CentreWare IS, click Printer Defaults.
3. If desired, change the setting for Front Panel Menus (under User Preferences on the
Printer Defaults page).
■ Select Off to have all menus available.
■ Select On to lock all menu items that change printer setup values.
4. Click Save Changes on the bottom of the page.

Xerox Phaser 7300 Specifications

General

Brand	Xerox
Model	Phaser 7300
Category	Printer
Language	English