that on models greater than or equal to 40 ppm color or greater than or equal to 45 ppm
monochrome the duplex function has been auto-enabled, during the setup and driver installation.
Some Xerox models below these speed bands may also be enabled with 2-sided printing settings
defaulted on at the time of install. Continuing to use the duplex function will reduce the
environmental impact of your work. However, should you require simplex/1-sided printing, you may
change the print settings in the print driver.
Paper Types
This product can be used to print on both recycled and virgin paper, approved to an environmental
stewardship scheme, which complies with EN12281 or a similar quality standard. Lighter weight
paper (60 g/m²), which contains less raw material and thus saves resources per print, may be used in
certain applications. We encourage you to check if this is suitable for your printing needs.
ENERGY STAR
The ENERGY STAR program is a voluntary scheme to promote the development
and purchase of energy-efficient models, which help to reduce environmental
impact. Details on the ENERGY STAR program and models qualified to ENERGY
STAR can be found at the following website: www.energystar.gov.
The ENERGY STAR and ENERGY STAR mark are registered United States
trademarks.
The ENERGY STAR Imaging Equipment Program is a team effort between
United States, European Union, Japanese governments, and the office
equipment industry to promote energy-efficient copiers, printers, fax,
multifunction printers, personal computers, and monitors. Reducing product
energy consumption helps combat smog, acid rain, and long-term changes to
the climate by decreasing the emissions that result from generating electricity.
For more information on energy or other related topics, go to www.xerox.com/about-xerox/
environment/enus.html or www.xerox.co.uk/about-xerox/environment/engb.html.
Power Consumption and Activation Time
The amount of electricity that a device consumes depends on the way the device is used. This device
is designed and configured to enable you to reduce your electricity usage.
Power Saver modes are enabled on your device to reduce energy consumption. After the last print,
the device transitions to Ready mode. In this mode, the device can print again immediately. If the
device is not used for a specified period, the device transitions to Low Power mode, then to Sleep
mode. In these modes, to enable reduced-power consumption, only essential functions remain active.
The device takes longer to produce the first print after it exits the Power Saver modes than it takes to
print in Ready mode. This delay is the result of the system waking up and is typical of most imaging
devices on the market.
To save power, you can enable Auto Power Off mode on your device. If Auto Power Off mode is
enabled, you can configure the mode as follows:
• Always Allowed: The device powers off automatically after the specified time, and the cumulative
Low Power mode and Sleep mode timeouts have elapsed.
• Allowed ONLY When Conditions are Met: The device automatically powers off only after
timeouts have elapsed. The device also powers off if Fax, USB Drive, and Wired and Non-Wired
Network have not been activated.
256
Xerox
®
VersaLink
®
C605 Color Multifunction Printer
User Guide
Regulatory Information
To Next Page
Loading...
Need help?
General
Weight and Dimensions
