Xerox WorkCentre 7232 User Manual

4 CentreWare Internet Services
62 Xerox WorkCentre 7232/7242 System Administration Guide
POP3 Settings:
• Polling Interval – Enter the interval to check the POP3 server between 1 and 120
minutes in 1 minute increments.
6. Select [Apply] to reflect the new settings.
7. Enter the user ID and passcode, and then select [OK].
NOTE: The default user ID is "11111" and the default passcode is "x-admin".
8. When the reboot message appears, select [Reboot Machine].
HTTP
This page allows you to configure the HTTP settings.
NOTE: Some settings on this page will only be available after you restart CentreWare
Internet Services, or after the machine is switched off and on.
1. At the CentreWare Internet Services home page for the machine, select the
[Properties] tab.
2. In the [Properties] frame, select the plus symbol [+] to the left of the [Connectivity]
folder.
3. Select the plus symbol [+] to the left of the [Protocols] folder.
4. Select [HTTP].
5. Set up the following displayed in the frame.
• Connection – Displays whether the protocol is enabled or disabled.
• Physical Connection – Displays “Ethernet”. This is a display-only item.
• Keep Alive Timeout – Displays “60 seconds”. This is a display-only item.
• Maximum Connections – Enter the maximum number of connections between
1 and 15.
• Port Number – Enter the port to be used for HTTP communication.
• Secure HTTP (SSL) – Select whether or not to enable SSL/TLS communication.
• Secure HTTP Port Number – Enter the port number to be used for SSL/TLS
communication.
• Connection Time-Out – Allows you to specify the connection time-out period
when transmission fails
6. Select [Apply] to reflect the new settings.
7. Enter the user ID and passcode and then select [OK].
NOTE: The default user ID is "11111" and the default passcode is "x-admin".
8. When the reboot message appears, select [Reboot Machine].

Xerox WorkCentre 7232 Specifications

General

Brand	Xerox
Model	WorkCentre 7232
Category	All in One Printer
Language	English