16
Loading Copy Paper
will flash in the copy quantity display and the green indicator in the
copier diagram will flash when:
• a paper tray is empty.
• paper has not fed all the way into the copier.
• a paper tray is not closed properly.
If the paper has misfed, open the paper tray indicated by the flashing green
light on the copier diagram and remove the misfed paper.
• Do not reuse the misfed paper.
• Ensure that the paper is under the corner snubbers.
• Close the paper tray. Press Start to make the remaining copies.
1. Lift and pull open the paper tray.
Steps 3 and 4 for XC1250/ XC1255
copiers only
If paper is difficult to remove...
2. Open the right access door.
3. Remove any misfed paper. Close the
right access door.
1. Push down on the shiny plate until it locks
in position.
Note: The procedures for loading paper into
tray 1 and tray 2 are identical.
To Next Page
Loading...
Need help?
General