19
Making Copies on the Set Document Feeder
(XC865/ XC1044/ XC1045/ XC1255)
Use the Set Document Feeder (SDF) to make one collated copy of
originals. The SDF holds up to 20 originals (20 lb/80 gsm) in one job.
Ensure originals are in good condition, and that all staples and paper clips
have been removed. Use the document glass to make copies from
transparencies, facsimile paper, or originals having other unusual
characteristics. For reliable copying operation, use originals within the
following ranges:
Paper weight range: 16 to 24 lb/60 to 90 gsm
Paper size range: 5.5
×8.5"/A5, 8.5×11"/A4 and 8.5×14"/216× 353 mm
The SDF comes from the factory with the Auto Start feature enabled.
Refer to Customizing Your Copier section of this User Guide for
information about changing this setting.
1. Select the required paper tray.
2. Select the desired copy features from the
control panel.
• The maximum copy quantity is 1.
Reinsert the originals into the SDF for
each set required.
1. Adjust the paper guide to the original size.
Note: Writing that is very close to the leading
or trailing edge of the original may not copy.
Turning the original around in the SDF may
help.
4. Insert up to 20 originals face down into the
SDF until the green SDF light on the
copier diagram comes on.
• When copying originals that are larger
than 8.5
×11"/A4, fold out the extension
tray located on the SDF.
To Next Page
Loading...
Need help?
General