32
Programmable Feature Setting 10
Use the following procedure to change the preset Reduction/Enlargement
default setting. This feature allows you to set a specific preset reduction or
enlargement between 70 – 141%.
1. Select the Toner Saver mode.
1. Press again and hold the Exposure Mode
key for approximately 4 to 6 seconds.
• The light next to Auto mode will light.
• The lights within the Copier Diagram
will flash.
1. Press the 10’s unit key until the number
10 is displayed.
2. Press Start.
• The current reduction/enlargement
setting will flash.
1. Press the variable percentage keys until
the desired percentage is displayed.
2. Press Start to store the selection.
3. Press the Clear key to continue making
other changes. Press the Exposure mode
key to return to the copy mode.
To Next Page
Loading...
Need help?
General