Xerox XTRAVEL-SCAN - Travel Scanner 100 User Manual

Xerox Travel Scanner 100 User’s Guide 71
Maintenance
5. Place the cleaning sheet in the scanner.
The scanner pulls in the cleaning sheet. The scanner will move the cleaning sheet back and forth during
cleaning.
6. When cleaning is complete the scanner will clear the cleaning sheet out of the scanner. Remove the
cleaning sheet when the utility prompts you to. Do not forcefully pull the page out of the scanner, the
scanner will release the page when it has fully exited out of the scanner.
Cleaning from the Windows Control Panel:
If you did not install One Touch during the initial installation of the scanner driver, see page 8, please
follow these steps to open the scanner’s hardware properties.
1. Open the Windows Control Panel.
2. Double-click on Scanners and Cameras.
If you do not see Scanners and Cameras, open Printers and Other Hardware then you should see this
option.
3. Your Xerox Travel Scanner 100 should be listed as one of the attached scanners. Right-click on the
scanner and choose Properties to open the Device Settings for your scanner.
4. You can now follow the steps in this section to clean the scanner.
Additional Cleaning Method
The standard cleaning method for your scanner is to use the dry cleaning sheet in the scanner. If lines,
smudges or blurry areas are still in the scanned image you can try cleaning the scanner with Isopropyl
rubbing alcohol.
Please use caution when cleaning the scanner and take appropriate care to prevent injury, skin irritation or
damage to the scanner.
• Scanner cleaning sheet.
• A bottle of 70% solution Isopropyl rubbing alcohol.
• Protective rubber or latex gloves.
• Protective eye glasses.

Xerox XTRAVEL-SCAN - Travel Scanner 100 Specifications

General

Brand	Xerox
Model	XTRAVEL-SCAN - Travel Scanner 100
Category	Scanner
Language	English