Xilinx ML605 User Manual

54 www.xilinx.com ML605 Hardware User Guide
UG534 (v1.2.1) January 21, 2010
Chapter 1: ML605 Evaluation Board
FPGA_PROG_B Pushbutton SW4 (Active-Low)
This switch grounds the FPGA's PROG_B pin when pressed. This action clears the FPGA.
See the Virtex-6 FPGA Data Sheet for more information on clearing the contents of the
FPGA. [Ref 4]
SYSACE_RESET_B Pushbutton SW3 (Active-Low)
When the System ACE CF configuration mode pin is high (enabled by closing DIP switch
S1 switch 4), the System ACE CF controller configures the FPGA from the CompactFlash
card when a card is inserted or the SYSACE RESET button is pressed. See “5. System ACE
CF and CompactFlash Connector,” page 24 for more details.
X-Ref Target - Figure 1-24
Figure 1-24: FPGA PROG_B Pushbutton SW4
FPGA_PROG_B
FPGA PROG
Pushbutton
Silkscreen:
PROG
VCC2V5
RP4
4.7K
14
5%
1
P1
P2
P4
P3
2
4
3
SW4
UG534_24_073109
X-Ref Target - Figure 1-25
Figure 1-25: System ACE CF RESET_B Pushbutton SW3
Pushbutton
silkscreen:
“SYSACE RESET”
SYSACE_RESET_B
1
SW3
2
4
3
P1
P2
P4
P3
UG534_25_073109

Xilinx ML605 Specifications

General

Brand	Xilinx
Model	ML605
Category	Motherboard
Language	English