Xinje DS2 series Manual

1
►► Safety notes
 Confirmation
 Do not use the drivers that are broken, lack of parts or wrong types.
 Installation
 Make sure all the external powers are cut off before install the drivers.
 Wiring
 Please cut off all the powers before wiring.
 Connect the AC power to the power terminals of driver.
 Do not connect U, V, W terminals of driver with 3-phase power supply.
 Please use 2mm
2
cables to ground the GND terminal of driver.
 Maintenance and running
 Install the panel cover when power on.
 Do not touch the terminals in 5 minutes after power off.
 Do not connect motor with load when test running.
 Set the suitable power consumption parameters before connecting the machine.
 Do not change the wiring with electricity.
 Do not touch the radiator when running.
►► Confirmation after getting the products
1. Please confirm the following items after getting the products.
Item
Contents
The type is what you ordered?
Check the label of driver and motor
Does the motor shaft rotate well?
Can rotate by manual. Cannot rotate by manual for
brake types
Is there any damage?
Check if the cover has damage during transporting
Is the screw loose?
Check the screw with screwdriver
Check the motor code
Check if the driver and the motor code is matched
Please contact us if there are any problems in these items.
2. Type
(1) Servo driver

Xinje DS2 series Specifications

General

Brand	Xinje
Model	DS2 series
Category	Servo Drives
Language	English