Xinje DS2 series Manual

48
F3-07
The speed when alarming
rpm
F3-08
The internal torque command when alarming
%
F3-09
The V-REF value when alarming
V
F3-10
The T-REF value when alarming
V
F3-11
Alarm/warn code 2 when alarming
F3-12
Alarm/warn code 3 when alarming
F3-13
Alarm/warn code 4 when alarming
F3-14
Alarm/warn code 5 when alarming
F3-15
Alarm/warn code 6 when alarming
F3-16
Alarm/warn code 7 when alarming
※1: when F3-00=0, no alarm
※2: when F3-01=0, no warning
 Set to default value (parameter F4-XX)
F4-00=1,all parameter will back to default value.
Note: When drive is on, the change cannot be done. The operations must be done when servo
is OFF.
 External monitor (parameter F5-XX)
In auxiliary function, choose F5-00, it will show C-OUT. COM1 is available, control panel is
invalid. User can debug the servo through PC.
Press STATUS/ESC to exit.
5. Error alarm operation (parameter E-XX)
When error appears, the drive will enter alarm status and display the alarm no.;
when there is no error, the alarm status cannot see. System error display “E-XXX”.
Under the alarm status ,short press ENTER can reset the error. If the power is off

Xinje DS2 series Specifications

General

Brand	Xinje
Model	DS2 series
Category	Servo Drives
Language	English