16
terminals to malfunction. Take appropriate action to avoid
corrosive gas.
Do not install the servo drive in hot and humid locations or
locations subject to excessive dust or iron powder in the air.
3）Installation direction
As shown in the below picture, the direction of installation should be perpendicular to the
direction of the wall.
Use natural convection or fan to cool the servo drive. Be sure to comply with the installation
direction requirement and fix the servo drive firmly on the mounting surface. For a drive
equipped with a regenerative resistor at the bottom, it shall pay attention to the heat
dissipation of the mounting surface to avoid overheating of the drive or causing fire.
To Next Page
Loading...
Need help?
General
