2
Do not connect a three-phase power supply to the U, V, or W output terminals.
Use 2mm
2
wire to grounding the ground terminals.
For wiring please make sure that the encoder lines, power lines in loose state, not
tight, so as to avoid cable damage.
Product running and maintenance
Do not remove the panel cover while the power is ON.
Do not touch terminals for 10 minutes after the power has been turned OFF.
Do not connect with any motor when trial operation.
Before starting operation with a machine connected, change the settings to match
the parameters of the machine.
Do not attempt to change wiring while the power is ON.
Do not touch the heat sinks during operation.
1. Product description and specification
1-1. Servo drive
1-1-1. Parts description
To Next Page
Loading...
Need help?
General
